OSPF Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1540
configure ospf priority
configure ospf [area <area-identifier> | vlan [<vlan-name> | all]] priority
<priority>
Description
Configures the priority used in the designated router and backup designated router election algorithm
for one or all OSPF interface(s) or for all the interfaces within the area.
Syntax Description
Default
The default setting is 1.
Usage Guidelines
The range is 0 through 255, and the default setting is 1. Setting the value to 0 ensures that the router is
never selected as the designated router or backup designated router.
Example
The following command sets all the interfaces in area 1.2.3.4 to not be selected as the designated router:
configure ospf area 1.2.3.4 priority 0
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms with a core license.
area-identifier Specifies an OSPF area.
vlan-name Specifies a VLAN name.
all Specifies all VLANs.
priority Specifies a priority range. The range is 0 through 255.
To Next Page
Loading...