configure ospfv3 area add range
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1613
configure ospfv3 area add range
configure ospfv3 {domain <domainName>} area <area-identifier> add range
<ipv6netmask> [advertise | noadvert] inter-prefix
Description
Configures a range of IP addresses in an OSPFv3 area to be aggregated.
Syntax Description
Default
No OSPFv3 inter-area-prefix LSAs are configured.
Usage Guidelines
If advertised, the aggregated IP range is exported as a single LSA by the ABR.
Example
The following command is used to summarize a certain range of IP addresses within an area and export
them out as a single address to area 0.0.0.1:
configure ospfv3 area 0.0.0.1 add range 2aaa:456:3ffe::/64 advertise inter-prefix
History
This command was first available in ExtremeWare XOS 11.2
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
domainName Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
area-identifier Specifies an OSPFv3 area, a four-byte, dotted decimal number.
ipv6netmask Specifies an IPv6 address / prefix length.
advertise Specifies to advertise the aggregated range of IP addresses.
noadvert Specifies not to advertise the aggregated range of IP addresses.
inter-prefix Specifies aggregate, inter-area-prefix LSAs.
To Next Page
Loading...