show lacp counters
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
375
show lacp counters
show lacp counters
Description
Displays all LACP, or dynamic link aggregation, counters for all member ports in the system.
Syntax Description
This command has no parameters or variables.
Default
N/A.
Usage Guidelines
This command displays the following information for all link aggregation groups (LAGs):
● LACP PDUs dropped on non-LACP ports
● LACP bulk checkpointed messages sent
● LACP bulk checkpointed messages received
● LACP PDUs checkpointed sent
● LACP PDUs checkpointed received
● LAG group ID
● Member port
● Packets received
● Packets dropped from PDU error
● Packets dropped because LACP is not enabled on this port
● Packets dropped because sender’s system MAC address matches that of receiver
● Packets successfully transmitted
● Packets with errors during transmission
Example
The following command displays LACP counters:
show lacp counters
The following is sample output from this command on a modular switch:
LACP PDUs dropped on non-LACP ports : 519392
LACP Bulk checkpointed msgs sent : 1
LACP Bulk checkpointed msgs recv : 0
LACP PDUs checkpointed sent : 575616
LACP PDUs checkpointed recv : 0
To Next Page
Loading...