Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
374
● Partner Key
■ LACP key automatically generated by the system to which this aggregator is connected.
■ If this number is lower than the number displayed for the Actor Key, the partner system is the
controlling partner in the LAG.
● Agg Count
■ Identifies the number of ports added to the aggregator for that LAG.
Example
The following command displays the LACP LAGs on the switch:
show lacp
The following is sample output from this command on a modular switch:
LACP Up : Yes
LACP Enabled : Yes
System MAC : 00:04:96:10:33:60
LACP PDUs dropped on non-LACP ports : 0
Lag Actor Actor Partner Partner Partner Agg
Sys-Pri Key MAC Sys-Pri Key Count
--------------------------------------------------------------------------------
2:1 90 0x07d1 00:01:30:f9:9c:30 601 0x1391 2
4:5 100 0x0fa5 00:01:30:f9:9c:30 321 0x1f47 16
4:9 677 0x0fa9 00:01:30:f9:9c:30 87 0x0fa9 8
History
This command was first available in ExtremeWare XOS 11.3.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...