Extreme Networks ExtremeWare XOS - Configure Diffserv Examination Code-Point

QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
866
configure diffserv examination code-point
configure diffserv examination code-point <code-point> {qosprofile}
<qosprofile>
Description
Configures the default ingress DiffServ code points (DSCP) to QoS profile mapping.
Syntax Description
Default
See Table 22.
Usage Guidelines
You can specify up to 64 different code points for each port. Code point values are grouped and
assigned to the default QoS profiles as shown in Table 22.
BlackDiamond 10808 and 12804 switch only. If a port is in more than one virtual router, you cannot set
per port DiffServ examination code points. The default VLAN DiffServ examination mappings apply on
ports in more than one VR. If you attempt to configure examining DiffServ information on a port that is
in more than one virtual router, the system returns the following message:
Warning: Port belongs to more than one VR. Port properties related to diff serv and
code replacement will not take effect.
code-point Specifies a DiffServ code point (a 6-bit value in the IP-TOS byte in the IP
header).
qosprofile Specifies the QoS profile to which the DiffServ code point is mapped.
Table 22: Default DiffServ code point-to-QoS profile mapping
Code point
BlackDiamond 10808 and
12804 switch QoS profile
BlackDiamond 8800 series switches and Summit
X450 family of switches QoS profile
0-7 QP1 QP1
8-15 QP2 QP1
16-23 QP3 QP1
24-31 QP4 QP1
32-39 QP5 QP1
40-47 QP6 QP1
48-55 QP7 QP1
56-63 QP8 QP8