RIPng Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1534
unconfigure ripng
unconfigure ripng {vlan <vlan-name> | tunnel <tunnel-name> | vlan all |
tunnel all}
Description
Resets RIPng parameters to the default value.
Syntax Description
Default
N/A.
Usage Guidelines
Issuing the command unconfigure ripng resets all the interfaces and the global configuration to the
defaults, and disables RIPng, as that is the default.
Example
The following command resets the RIPng configuration to the default for the VLAN finance:
unconfigure rip finance
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
vlan-name Specifies an IPv6 configured VLAN.
tunnel-name Specifies an IPv6 tunnel.
all Specifies either all IPv6 configured VLANs or all IPv6 tunnels.
To Next Page
Loading...