Extreme Networks ExtremeWare XOS - Terminate Process

terminate process
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
293
terminate process
terminate process <name> [forceful | graceful] {msm <slot>}
Description
Terminates the specified process on the switch.
Syntax Description
Default
N/A.
Usage Guidelines
If recommended by Extreme Networks Technical Support personnel, you can stop a running process.
The
forceful option quickly terminates a process on demand. Unlike the graceful option, the process
is immediately shutdown without any of the normal process cleanup. The status of the operation is
displayed on the console. After a successful forceful termination of a process, a message similar to the
following appears:
Forceful termination success for snmpMaster
The graceful option terminates the process by allowing it to close all opened connections, notify peers
on the network, and other types of process cleanup. After this phase, the process is finally terminated.
After a successful graceful termination of a process, a message similar to the following appears:
Successful graceful termination for snmpSubagent
name Specifies the name of the process to terminate. You can terminate the
following processes:
• exsshd (only available if you have installed the SSH module)
•lldp
• netLogin
•ospf
• snmpMaster
• snmpSubagent
•telnetd
• thttpd
• tftpd
forceful Specifies a forceful termination.
graceful Specifies a graceful termination.
slot Specifies the MSM where the process should be terminated. A specifies the
MSM installed in slot A, and B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.