Extreme Networks ExtremeWare XOS - Configure Bgp Peer-Group Soft-Reset

configure bgp peer-group soft-reset
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1719
configure bgp peer-group soft-reset
configure bgp peer-group <peer-group-name> soft-reset {in | out}
Description
Applies the current input/output routing policy to the neighbors in the peer group.
Syntax Description
Default
N/A.
Usage Guidelines
The input/output routing policy is determined by the route policy configured for the neighbors in the
peer group on the input/output side of the router. This command does not affect configuration of the
switch.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
Modifying the following parameters automatically disables and enables the neighbors before changes
take effect:
● remote-as
● timer
● source-interface
● soft-in-reset
● password
Example
The following command applies the current input routing policy to the neighbors in the peer group
outer:
configure bgp peer-group outer soft-reset in
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
peer-group-name Specifies a peer group.
in Specifies to apply the input routing policy.
out Specifies to apply the output routing policy.