Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
300
clear slot
clear slot <slot>
Description
Clears a slot of a previously assigned module type.
Syntax Description
Default
N/A.
Usage Guidelines
All configuration information related to the slot and the ports on the module is erased. If a module is
present when you issue this command, the module is reset to default settings.
If a slot is configured for one type of module, and a different type of module is inserted, the inserted
module is put into a mismatch state (where the inserted module does not match the configured slot),
and is not brought online. To use the new module type in a slot, the slot configuration must be cleared
or configured for the new module type. Use the
configure slot module command to configure the
slot.
Example
The following command clears slot 2 of a previously assigned module type:
clear slot 2
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available only on modular switches.
slot Specifies the slot number.
To Next Page
Loading...