Extreme Networks ExtremeWare XOS - Show Access-List Usage Acl-Range

show access-list usage acl-range
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
855
show access-list usage acl-range
show access-list usage acl-range port <port>
Description
Displays the number of Layer 4 port ranges consumed by the ACLs on the slices that support a
particular port.
Syntax Description
Default
N/A.
Usage Guidelines
The BlackDiamond 8800 a-series and e-series modules and Summit X450a and X450e series switches can
support a total of sixteen Layer 4 port ranges among the slices that support each group of 24 ports.
Use this command to display how many of these Layer 4 ranges are currently consumed by the ACLs
on the slices that support a particular port. The output of this command also displays which ports share
the same slices as the specified port.
This command will return an error if the port specified is on a BlackDiamond 8800 original series
module, or a Summit X450 series switch.
Example
The following example displays the Layer 4 range usage on port 9:1:
show access-list usage acl-range port 9:1
The output of this command is similar to the following:
Ports 9:1-9:12, 9:25-9:36
L4 Port Ranges: Used: 4 Available: 12
History
This command was first available in ExtremeWare XOS 11.5.
Platform Availability
This command is available only on the BlackDiamond 8800 a-series and e-series modules and Summit
X450a and X450e series switches.
port Specifies to display the usage for the slices that support this port.