Commands for Managing the Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
230
show snmpv3 extreme-target-addr-ext
show snmpv3 extreme-target-addr-ext [[hex <hex_addr_name>] | <addr_name>]
Description
Displays information about SNMPv3 target addresses enhanced or standard mode.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display entries in the SNMPv3 extremeTargetAddressExtTable.
Example
The following command displays the entry for the target address named A1:
show snmpv3 extreme-target-addr-ext A1
The following is sample output from this command:
Target Addr Name : A1
Mode : Enhanced
IgnoreMPModel : No
UseEventComm : Yes
History
This command was first available in ExtremeWare XOS 10.1.
The
hex_addr_name parameter was added in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
hex_addr_name Specifies an identifier for the target address. The value is to be supplied as a
colon separated string of hex octets.
addr_name Specifies a string identifier for the target address.
To Next Page
Loading...