VLAN Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
754
create protocol
create protocol <name>
Description
Creates a user-defined protocol filter.
Syntax Description
Usage Guidelines
Protocol-based VLANs enable you to define packet filters that the switch can use as the matching
criteria to determine if a particular packet belongs to a particular VLAN.
After you create the protocol, you must configure it using the
configure protocol command. To
assign it to a VLAN, use the
configure vlan <vlan_name> protocol <protocol_name> command.
Example
The following command creates a protocol named fred:
create protocol fred
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
name Specifies a protocol filter name. The protocol filter name can have a maximum
of 31 characters.
To Next Page
Loading...