CNA Agent Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
2000
show cna-testplug
show cna-testplug
Description
Displays the statistics and connection status with the CNA software from Avaya. The display includes
configured CNA Agent (test plug) and CNA Server (scheduler) connections and the number of tests
conducted on each connection.
Syntax
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays the following information:
● Hardware Name—The name of the Extreme Networks device running the CNA Agent (test plug)
● Firmware version—The version of ExtremeWare XOS firmware running on the device
● Interface VLAN—VLAN (and virtual router) interface the CNA Server uses to schedule and run the
tests
● IP address on the interface—IP address of the interface the CNA Server uses; the connection on
which the CNA Agent tests and sends results
● CNA Test plug version—Version of CNA Agent (test plug) software, in the following format:
MajorRev.MinorRev.Build
● Interface version with Scheduler—Shows compatibility between the CNA Agent (test plug) and the
CNA Server (scheduler) software
● Enabled or Disabled
● Status—Connection status to the CNA Server:
■ Registered
■ Unregistered
● Errors—Number of errors in tests of connectivity
● Total tests received—Total test requests received by the CNA Agent
● Scheduler (SBC)—IP address and port number on which the CNA Server communicates with the
CNA Agent; the connection on which the CNA Agent listens
To Next Page
Loading...