Extreme Networks ExtremeWare XOS - Configure Rip Vlan Txmode

configure rip vlan txmode
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1471
configure rip vlan txmode
configure rip [vlan <vlan-name> | all] txmode [none | v1only | v1comp |
v2only]
Description
Changes the RIP transmission mode for one or all VLANs.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
The following command configures the transmit mode for the VLAN finance to transmit version 2
format packets to the broadcast address:
configure rip finance txmode v1comp
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
none Specifies to not transmit any packets on this interface.
v1only Specifies to transmit RIP version 1 format packets to the broadcast address.
v1comp Specifies to transmit RIP version 2 format packets to the broadcast address.
v2only Specifies to transmit RIP version 2 format packets to the RIP multicast
address.
vlan-name Specifies to apply settings to a specific VLAN name.
all Specifies all VLANs.