Extreme Networks ExtremeWare XOS - Download Bootrom

download bootrom
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1897
download bootrom
download bootrom [[<ipaddress> | <hostname>] <filename> {{vr} <vrname>}
| memorycard <filename>] {msm <slotid>}
Description
Downloads a BootROM image after the Summit X450 family switch or the BlackDiamond 10808 switch
have booted. The downloaded image replaces the BootROM in the onboard FLASH memory.
Syntax Description
Default
N/A.
Usage Guidelines
NOTE
The Summit X450 family of switches do not support user-created VRs.
Upgrade the BootROM image only when asked to do so by an Extreme Networks technical
representative.
Prior to downloading the BootROM image on the switch, you must download the image you received
from Extreme Networks to a TFTP server on your network. On the BlackDiamond 10808 switch, you
can also download the image to the external compact flash memory card.
Specify the
ipaddress or hostname parameters to download a BootROM image from a TFTP server on
the network.
ipaddress Specifies the IP address of the TFTP server.
hostname Specifies the hostname of the TFTP server.
memorycard Specifies that the BootROM image should be obtained from the external
compact flash memory card.
NOTE: This parameter is available only on the BlackDiamond 10808 switch.
vrname Specifies the name of the virtual router.
NOTE: The Summit X450 family of switches do not support user-created
virtual routers (VRs).
filename Specifies the name of the file that contains the BootROM image.
slotid Specifies the MSM where the BootROM image should be downloaded.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on the BlackDiamond 10808 switch.