configure mvr add vlan
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1805
configure mvr add vlan
configure mvr add vlan <vlan-name>
Description
Configures a VLAN as an MVR VLAN.
Syntax Description
Default
N/A.
Usage Guidelines
Configures MVR on the specified VLAN. When a multicast stream in the specified MVR address range
is received on the VLAN, it is leaked to all other VLAN ports where the corresponding IGMP join
message is received. By default, the entire multicast address range 224.0.0.0/4, except for the multicast
control range 224.0.0.0/24 is used for MVR. To change the MVR address range, use the following
command:
configure mvr vlan <vlan-name> mvr-address {<policy-name> | none}
Example
The following command configures VLAN v1 as an MVR VLAN:
configure mvr add vlan v1
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
vlan-name Specifies a VLAN name.
To Next Page
Loading...