Extreme Networks ExtremeWare XOS - Unconfigure Inline-Power Priority Ports

unconfigure inline-power priority ports
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
553
unconfigure inline-power priority ports
unconfigure inline-power priority ports [all | <port_list>]
Description
On modular switches, unconfigures the PoE priority on the specified ports, and returns the ports to the
default PoE port priority value of low.
Syntax Description
Default
Low.
Usage Guidelines
Use this to reset the PoE port priority on specified ports on modular switches to the default value of
low.
If there are multiple ports on a modular switch at the same priority level (either configured, or by
default) and one of the ports must have power withdrawn because of excessive power demands, those
ports with the lower port number are powered first. The higher port numbers have power withdrawn
first in the case of equal PoE port priorities.
Example
The following command resets the PoE priority on ports 4 – 6 on slot 3 to low:
unconfigure inline-power priority ports 3:4-3:6
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on the G48P and G48Pe modules installed in the BlackDiamond 8800 series
switch.
all Specifies all ports.
port_list Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.