Extreme Networks ExtremeWare XOS - Show Inline-Power

show inline-power
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
541
show inline-power
show inline-power
Description
Displays inline power information for the specified stand-alone PoE switches.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
On stand-alone PoE switches, the output indicates the following inline power status information:
● Inline power status—The status of inline power. The status conditions are:
■ Enabled
■ Disabled
● Power usage threshold
● Firmware status—The operational status of the slot. The status conditions are:
■ Operational
■ Not operational
■ Disabled
■ Subsystem failure
● Measured power—The amount of power, in watts, that currently being used by the switch.
● Legacy—The status of the legacy mode, which allows detection of many non-standard PDs.
Example
The following command displays inline power information for the Summit X450e-24p switch:
show inline-power
Following is sample output from this command:
Inline Power System Information
Configured : Enabled
Power Usage Threshold : 70 percent
Disconnect Precedence : deny-port
Budgeted Measured
Firmware Status Power (Watts) Power (Watts) Legacy
Operational 405 W 0 W Disabled