Extreme Networks ExtremeWare XOS - Show Switch

Commands for Accessing the Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
106
show switch
show switch {detail}
Description
Displays the current switch information.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
The show switch command displays:
● sysName, sysLocation, sysContact
● MAC address
● System health check
● Recovery mode
● Watchdog state
● Current date, time, system boot time, and time zone configuration
● Any scheduled reboot information
● MSM information (available only on modular switches)
● Current state (available only on stand-alone switches)
■ OPERATIONAL
■ OPERATIONAL (OverHeat)
■ FAILED
● Software image information (primary/secondary image and version)
● Configuration information (primary/secondary configuration and version)
This information may be useful for your technical support representative if you have a problem.
Depending on the software version running on your switch, additional or different switch information
may be displayed.
Example
The following command displays current switch information:
show switch