show slot
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
407
show slot
show slot {<slot> {detail} | detail }
Description
Displays the slot-specific information.
Syntax Description
Default
N/A.
Usage Guidelines
NOTE
You may see slightly information displayed depending on the platform and configuration you are using.
The show slot command displays the following information:
● The slot number
● The type of module installed in the slot
● The type that the module is configured as
● The state of the module, whether the power is down, if the module is operational, if a diagnostic
being run, if there is a mismatch between the slot configuration and the module in the slot
● The number of ports on the module
If you do not specify a slot number, information for all slots is displayed.
The display also includes a notice of insufficient power, should that arise.
The
show slot command displays the following states, among others:
● Empty (BD 8800 series switch only—This also displays if you have a module in the chassis that is
unsupported by the current software you are running.)
● Down
● Power ON
● Powered OFF
● Booting
● Initializing
● VLAN sync
slot Specifies a slot on a modular switch.
detail Specifies detailed port information.
To Next Page
Loading...