IP Unicast Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1366
disable iparp refresh
disable iparp {vr <vr_name>} refresh
Description
Disables IP ARP to refresh its IP ARP entries before timing out.
Syntax Description
Default
Enabled.
Usage Guidelines
The purpose of disabling ARP refresh is to reduce ARP traffic in a high node count layer 2 switching
only environment.
If you do not specify a virtual router, the command applies to the current virtual router.
Example
The following command disables IP ARP refresh:
disable iparp refresh
History
This command was first available in ExtremeWare XOS 10.1.
The
vr option was added in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
vr_name Specifies a virtual router.
To Next Page
Loading...