Commands for Configuring LLDP
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
482
configure lldp ports vendor-specific med policy
application
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-
specific med policy application [voice | voice-signaling |guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-
video | video-signaling] vlan <vlan_name> dscp <dscp_value> {priority-
tagged}
Description
Configures the LLDP port to advertise or not advertise MED network policy TLVs. This TLV advertises
VLAN configuration and associated Layer 2 and Layer 3 attributes that apply for a set of specific
applications on that port. You can advertise up to 8 TLVs, each for a specific application, per port/
VLAN. Each application type can exist only once per port. This TLV tells the endpoint the specific
VLAN to use for the specific application, along with its unique priority.
Syntax Description
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.
advertise Specifies to send the information to neighbors.
voice Specifies voice application on specified port/VLAN(s).
voice-signaling Specifies voice signaling application on specified port/VLAN(s).
guest-voice Specifies guest voice application on specified port/VLAN(s).
guest-voice-signaling Specifies guest voice signaling application on specified port/VLAN(s).
softphone-voice Specifies soft phone voice application on specified port/VLAN(s).
video-conferencing Specifies videoconferencing application on specified port/VLAN(s).
streaming-video Specifies streaming video application on specified port/VLAN(s).
video-signaling Specifies video signaling application on specified port/VLAN(s).
vlan_name Specifies the VLAN the specified application is using.
NOTE: This parameter does not apply when the no-advertise parameter is
configured.
dscp_value Specifies the DSCP value for the specified application. This is a 6-bit value
from 0 to 63.
NOTE: This parameter does not apply when the no-advertise parameter is
configured.
priority-tagged Use this if you want priority tagging, and the VLAN is configured as untagged
on the port. (The endpoint sends out frames for the specified application with
a tag of 0.)
NOTE: This parameter does not apply when the no-advertise parameter is
configured.
To Next Page
Loading...