IP Multicast Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1804
configure mvr add receiver
configure mvr vlan <vlan-name> add receiver port <port-list>
Description
Configures a port to receive MVR multicast streams.
Syntax Description
Default
N/A.
Usage Guidelines
This command is used to add a group of virtual ports for multicast forwarding through MVR. By
default, some ports on non-MVR VLANs (router ports, primary and secondary EAPS ports), are
excluded from the MVR cache egress list. This command is used to override these rules, so that if valid
IGMP memberships are received, or a router is detected, streams would be forwarded out on the ports.
Example
The following command adds the ports 1:1 and 1:2 of VLAN v1 to MVR for forwarding:
configure mvr vlan v1 add receiver port 1:1-1:2
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
vlan-name Specifies a VLAN name.
port-list A list of ports or slots and ports.
To Next Page
Loading...