Extreme Networks ExtremeWare XOS - Configure Protocol Add

configure protocol add
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
729
configure protocol add
configure protocol <name> add [etype | llc | snap] <hex> {[etype | llc |
snap] <hex>}
Description
Configures a user-defined protocol filter.
Syntax Description
Default
N/A.
Usage Guidelines
Supported protocol types include:
● etype – IEEE Ethertype.
● llc – LLC Service Advertising Protocol.
● snap – Ethertype inside an IEEE SNAP packet encapsulation.
A maximum of 15 protocol filters, each containing a maximum of six protocols, can be defined.
The protocol filter must already exist before you can use this command: use the
create bvlan
command to create the protocol filter.
No more than seven protocols can be active and configured for use.
Example
The following command configures a protocol named Fred by adding protocol type LLC SAP with a
value of FFEF:
configure protocol fred add llc 0xfeff
History
This command was first available in ExtremeWare XOS 10.1.
name Specifies a protocol filter name.
hex Specifies a four-digit hexadecimal number between 0 and FFFF that
represents:
• The Ethernet protocol type taken from a list maintained by the IEEE.
• The DSAP/SSAP combination created by concatenating a two-digit LLC
Destination SAP (DSAP) and a two-digit LLC Source SAP (SSAP).
• The SNAP-encoded Ethernet protocol type.