Extreme Networks ExtremeWare XOS - Configure Log Target Severity

configure log target severity
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
589
configure log target severity
configure log target [console | memory-buffer | nvram | primary-msm |
backup-msm | session | syslog [all | <ipaddress> | <ipPort> {vr <vr_name>}
[local0 ... local7]]] {severity <severity> {only}}
Description
Sets the severity level of messages sent to the target.
Syntax Description
Default
By default, targets are sent messages of the following severity level and above:
● console display—info
● memory buffer—debug-data
● NVRAM—warning
● session—info
● syslog—debug-data
● primary MSM—error (modular switches only)
● backup MSM—error (modular switches only)
If a virtual router is not specified, VR-Mgmt is used.
console Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
primary-msm Specifies the primary MSM.
NOTE: This parameter is available only on modular switches.
backup-msm Specifies the backup MSM.
NOTE: This parameter is available only on modular switches.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
all Specifies all of the remote syslog servers.
ipaddress Specifies the syslog IP address.
ipPort Specifies the UDP port number for the syslog target.
vr_name Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
local0 ... local7 Specifies the local syslog facility.
severity Specifies the least severe level to send (if the keyword only is omitted).
only Specifies that only the specified severity level is to be sent.