Extreme Networks ExtremeWare XOS - Show Log Configuration Target

Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
680
show log configuration target
show log configuration target {console | memory-buffer | nvram | primary-
msm | backup-msm | session | syslog {<ipaddress> | <ipPort> | vr <vr_name>}
{[local0 ... local7]}}
Description
Displays the log configuration for the specified target.
Syntax Description
Default
If no options are specified, the command displays the configuration for the current session and console
display.
If a virtual router is not specified, VR-Mgmt is used.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
This command displays the log configuration for the specified target. The associated filter, severity,
match expression, and format is displayed.
console Show the log configuration for the console display.
memory-buffer Show the log configuration for volatile memory.
nvram Show the log configuration for NVRAM.
primary-msm Specifies the primary MSM.
NOTE: This parameter is available only on modular switches.
backup-msm Specifies the backup MSM.
NOTE: This parameter is available only on modular switches
session Show the log configuration for the current session (including console display).
syslog Show the configuration for the specified syslog target.
ipaddress Specifies the syslog IP address.
ipPort Specifies the UDP port number for the syslog target.
vr_name Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
local0 ... local7 Specifies the local syslog facility.