Extreme Networks ExtremeWare XOS - Enable Netlogin

Network Login Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1082
enable netlogin
enable netlogin [{dot1x} {mac} {web-based}]
Description
Enables Network Login authentication modes.
Syntax Description
Default
All types of authentication are disabled.
Usage Guidelines
Any combination of types of authentication can be enabled on the same switch. At least one of the
authentication types must be specified on the command line.
To disable an authentication mode, use the following command:
disable netlogin [{dot1x} {mac} {web-based}]
Example
The following command enables web-based network login:
enable netlogin web-based
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
dot1x Specifies 802.1x authentication.
mac Specifies mac-based authentication.
web-based Specifies web-based authentication.