Extreme Networks ExtremeWare XOS - Configure Vrrp Vlan Vrid Preempt

VRRP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1310
configure vrrp vlan vrid preempt
configure vrrp vlan <vlan_name> vrid <vridval> preempt
Description
Specifies that a higher priority backup router preempts a lower priority master.
Syntax Description
Default
The default setting is preempt.
Usage Guidelines
The preempt mode controls whether a higher priority backup router preempts a lower priority master.
preempt allows preemption. The router that owns the virtual IP address always preempts, independent
of the setting of this parameter.
Example
The following command allows preemption:
configure vrrp vlan vlan-1 vrid 1 preempt
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
vlan_name Specifies the name of a VRRP VLAN.
vridval Specifies a VRRP Virtual Router ID (VRID). Value can be in the range of 1-
255.