configure esrp add elrp-poll ports
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1241
configure esrp add elrp-poll ports
configure esrp <esrpDomain> add elrp-poll ports [<ports> | all]
Description
Configures the ports of an ESRP domain where ELRP packet transmission is requested by ESRP.
Syntax Description
Default
All ports of an ESRP domain have ELRP transmission enabled.
Usage Guidelines
This command allows you to configure the ports in your network that might experience loops, such as
ports that connect to master, slave, or ESRP-aware switches, to receive ELRP packets. You do not need
to send ELRP packets to host ports.
Example
The following command enables ELRP packet transmission for slot 2, ports 3-5 on ESRP domain esrp1:
configure esrp esrp1 add elrp-poll ports 2:3-2:5
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
esrpDomain Specifies an ESRP domain name.
ports Specifies list of slots and ports.
all Specifies all ports in the ESRP domain.
To Next Page
Loading...