Extreme Networks ExtremeWare XOS - Configure Mld

IPv6 Multicast Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1866
configure mld
configure mld <query_interval> <query_response_interval>
<last_member_query_interval> {<robustness>}
Description
Configures the Multicast Listener Discovery (MLD) timers.
Syntax Description
Default
● query interval—125 seconds
● query response interval—10 seconds
● last member query interval—1 second
● robustness—2
Usage Guidelines
Timers are based on RFC2710. Specify the following:
● query interval—The amount of time, in seconds, the system waits between sending out general
queries. The range is 1 to 429,496,729 seconds.
● query response interval—The maximum response time inserted into the periodic general queries.
The range is 1 to 25 seconds.
● last member query interval—The maximum response time inserted into a group-specific query sent
in response to a leave group message. The range is 1 to 25 seconds.
● robustness—The degree of robustness of the network. The range is 2 to 7.
Example
The following command configures the MLD timers:
configure mld 100 5 1 3
History
This command was first available in ExtremeWare XOS 11.2.
query_interval Specifies the interval (in seconds) between general queries.
query_response_interval Specifies the maximum query response time (in seconds).
last_member_query_interval Specifies the maximum group-specific query response time (in seconds).
robustness Specifies the degree of robustness for the network.