BGP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1718
configure bgp peer-group route-policy
configure bgp peer-group <peer-group-name> route-policy [in | out] [none |
<policy>]
Description
Configures the policy for a peer group and all the neighbors of the peer group.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
The following command configures the route policy for the peer group outer and its neighbors using the
policy nosales:
configure bgp peer-group outer route-policy in nosales
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
peer-group-name Specifies a peer group.
in Specifies to install the policy on the input side.
out Specifies to install the policy on the output side.
none Specifies to remove the filter.
policy Specifies a policy.
To Next Page
Loading...