Extreme Networks ExtremeWare XOS - Configure Vlan Add Ports Stpd

STP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1204
configure vlan add ports stpd
configure vlan <vlan_name> add ports [all | <port_list>] {tagged |
untagged} stpd <stpd_name> {[dot1d | emistp | pvst-plus]}
Description
Adds one or more ports in a VLAN to a specified STPD.
Syntax Description
Default
Ports in the default STPD (s0) are in dot1.d mode.
Ports in user-created STPDs are in
emistp mode.
Usage Guidelines
To create a VLAN, use the create vlan command. To create an STP domain, use the create stpd
command.
In an EMISTP or PVST+ environment, this command adds a list of ports to a VLAN and a specified
STPD at the same time provided the carrier VLAN already exists on the same set of ports. You can also
specify the encapsulation mode for those ports.
In an MSTP environment, you do not need a carrier VLAN. A CIST controls the connectivity of
interconnecting MSTP regions and sends BPDUs across the regions to communicate region status. You
must use the dot1d encapsulation mode in an MSTP environment.
You cannot configure STP on the following ports:
● Mirroring target ports
● Software-controlled redundant ports
● Netlogin ports
vlan_name Specifies a VLAN name.
all Specifies all of the ports to be included in the STPD.
port_list Specifies the port or ports to be included in the STPD.
tagged Specifies the ports should be configured as tagged.
untagged Specifies the ports should be configured as untagged.
stpd_name Specifies an STPD name on the switch.
dot1d Specifies the STP encapsulation mode of operation to be 802.1d.
emistp Specifies the STP encapsulation mode of operation to be EMISTP.
pvst-plus Specifies the STP encapsulation mode of operation to be PVST+.