Power Over Ethernet Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
538
show inline-power info ports
show inline-power info {detail} ports <port_list>
Description
Displays inline power information for the specified ports.
Syntax Description
Default
N/A.
Usage Guidelines
NOTE
Ports in the denied or faulted state periodically display the searching state as the hardware retests the PD
state.
You can use this command to generate a summary report or a detailed report.
Summary output displays the following inline power information for the specified ports:
● State—Displays the port power state:
■ Disabled
■ Searching
■ Delivering
■ Faulted
■ Disconnected
■ Other
■ Denied
● PD’s power class—Displays the class type of the connected PD:
■ “-----”: disabled or searching
■ “class0”: class 0 device
■ “class1”: class 1 device
■ “class2”: class 2 device
■ “class3”: class 3 device
■ “class4”: class 4 device
● Volts—Displays the measured voltage. A value from 0 to 2 is valid for ports that are in a searching
state.
port_list Specifies one or more ports.
To Next Page
Loading...