Extreme Networks ExtremeWare XOS - Page 539

show inline-power info ports
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
539
● Curr—Displays the measured current, in milliamperes, drawn by the PD.
● Power—Displays the measured power, in watts, supplied to the PD.
● Fault—Displays the fault value:
■ None
■ UV/OV fault
■ UV/OV spike
■ Over current
■ Overload
■ Undefined
■ Underload
■ HW fault
■ Discovery resistance fail
■ Operator limit violation
■ Disconnect
■ Discovery resistance, A2D failure
■ Classify, A2D failure
■ Sample, A2D failure
■ Device fault, A2D failure
■ Force on error
The detail command lists all inline power information for the selected ports. Detail output displays the
following information:
● Configured Admin State—Displays the port’s configured state; Enabled or Disabled.
● Inline Power State—Displays the port power state.
● MIB Detect Status—Displays the port state as reported by SNMP; valid values are as follows:
■ disabled
■ searching
■ delivering
■ fault
■ test
■ otherFault
■ denyLowPriority
● Label—Displays the port’s configured label.
● Operator Limit—Displays the port’s configured operator limit value.
● PD Class—Displays the class type of connected PD:
● Max Allowed Power—Displays the amount of maximum allowed power for a device of this class.
● Measured Power—Displays the measured power, in watts, supplied to the PD.
● Line Voltage—Displays the measured voltage. A value from 0 to 2 is valid for ports in a searching
state.
● Current—Displays the measured current, in milliamperes, drawn by the PD.
● Fault Status—Displays the fault value.
● Detailed Status