Extreme Networks ExtremeWare XOS - Configure Snmpv3 Add User Clone-From

configure snmpv3 add user clone-from
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
147
configure snmpv3 add user clone-from
configure snmpv3 add user [[hex <hex_user_name>] | <user_name>] clone-from
[[hex <hex_user_name>] | <user_name>]
Description
Creates a new user by cloning from an existing SNMPv3 user.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to create a new user by cloning an existing one. After you have successfully cloned
the new user, you can modify its parameters using the following command:
configure snmpv3 add user [[hex <hex_user_name>] | <user_name>] {authentication [md5 |
sha] [hex <hex_auth_password> | <auth_password>]} {privacy [hex <hex_priv_password> |
<priv_password>]} {volatile}
Users cloned from the default users will have the storage type of non-volatile. The default names are:
admin, initial, initialmd5, initialsha, initialmd5Priv, initialshaPriv.
Example
The following command creates a user cloneMD5 with same properties as the default user initalmd5. All
authorization and privacy keys will initially be the same as with the default user initialmd5.
configure snmpv3 add user cloneMD5 clone-from initialmd5
History
This command was first available in ExtremeWare XOS 10.1.
The
hex_user_name parameter was added in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
hex_user_name Specifies the user name to add or to clone from. The value is to be supplies as
a colon separated string of hex octets.
user_name Specifies the user name to add or to clone from in ASCII format.