show sflow configuration
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
699
show sflow configuration
show sflow {configuration}
Description
Displays the current sFlow configuration.
Syntax Description
This command has no arguments or variables
Default
N/A.
Usage Guidelines
This command displays the sFlow configuration of your system.
The following fields are displayed:
● Global Status—sFlow is globally enabled or disabled
● Polling interval—How often the hardware is polled for statistics, in seconds
● Sampling rate—Packets are sampled, on average, once for every rate-number of packets
● Maximum cpu sample limit—Maximum number of packets per second sampled before sample
throttling takes effect
● Agent IP—IP address inserted into the sFlow data packets to identify the sFlow switch
● Collectors—To which IP address and port, and from which virtual router, the sFlow packets are sent
● Port Status—Enabled or disabled for statistics gathering
● Port Sample-rate—Shows the sampling rate configured for the port and the actual rate if CPU
throttling has taken effect
● Port Subsampling factor—See the command configure sflow ports sample-rate for details
Example
To display the sFlow configuration on your system, use the following command:
show sflow
The output from this command is similar to the following:
SFLOW Global Configuration
Global Status: enabled
Polling interval: 20
Sampling rate: 8192
Maximum cpu sample limit: 2000
SFLOW Configured Agent IP: 10.203.2.38 Operational Agent IP: 10.203.2.38
Collectors
To Next Page
Loading...