Extreme Networks ExtremeWare XOS - Configure Lldp Ports Management-Address

configure lldp ports management-address
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
457
configure lldp ports management-address
configure lldp ports [all | <port_list>] [advertise | no-advertise]
management-address
Description
Configures the LLDP port to advertise or not to advertise management address information to its
neighbors.
Syntax Description
Default
No advertise.
Usage Guidelines
With ExtremeWare XOS, you can only add one management address TLV per LLDPDU and the
information must be the IP address configured on the management VLAN. If no IP address is assigned
to the management VLAN, the system sends the system MAC address. LLDP does not send out IPv6
addresses in this field.
Example
The following command advertises the management address information for port 1:5:
configure lldp ports 1:5 advertise management-address
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
all Specifies all ports on the switch.
port_list Specifies one or more ports or slots and ports.
advertise Specifies to send the information to neighbors.
no-advertise Specifies not to send the information to neighbors.