Extreme Networks ExtremeWare XOS - Configure Ospfv3 Interface Area

configure ospfv3 interface area
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1629
configure ospfv3 interface area
configure ospfv3 {domain <domainName>} [vlan <vlan-name> | tunnel <tunnel-
name>] area <area-identifier>
Description
Moves an interface from one OSPFv3 area to another.
Syntax Description
Default
Area 0.0.0.0
Usage Guidelines
Use this command to move an already configured interface from one area to another. The instance ID
associated with the interface will be unchanged.
Example
The following command moves the VLAN accounting to the OSPFv3 area 0.0.0.6:
configure ospfv3 vlan accounting area 0.0.0.6
History
This command was first available in ExtremeWare XOS 11.2.
Platform Availability
This command is available on platforms with a Core or an Advanced Core license.
domainName Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
vlan-name Specifies an IPv6 configured VLAN.
tunnel-name Specifies an IPv6 tunnel.
area-identifier Specifies an OSPFv3 area, a four-byte, dotted decimal number.