configure sys-recovery-level
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
609
System MAC: 00:04:96:20:B4:13
SysHealth check: Enabled (Normal)
Recovery Mode: All
System Watchdog: Enabled
NOTE
All platforms display the software recovery setting as Recovery Mode.
Example
The following command configures a switch to not take an action when any software task exception
occurs:
configure sys-recovery-level none
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...