Extreme Networks ExtremeWare XOS - Page 633

disable log target
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
633
Configuration changes to the session target are in effect only for the duration of the console display or
telnet session, and are not saved in FLASH. Changes to the other targets are saved to FLASH.
You can also use the following command to disable displaying the log on the console:
disable log display
The disable log display command is equivalent to disable log target console-display
command.
Modular Switches Only. Note that the
backup-msm target is only active on the primary MSM, and the
primary-msm target is only active on the backup MSM.
Example
The following command disables log messages to the current session:
disable log target session
History
This command was first available in ExtremeWare XOS 10.1.
The
primary-msm and backup-msm options were first available in ExtremeWare XOS 11.0.
The
ipPort parameter was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.