Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
378
● Port priority
● Rx State—Receiving state of the port
■ Idle
■ Initialized
■ Current—Receiving LACP PDUs
■ Expired
■ Defaulted
● Sel Logic—Selection state of the port
■ Selected—Ports with a matching admin key on the remote end.
■ Unselected—Ports that failed to meet with a matching admin key on the remote end.
■ Standby—Ports that exceed the number of ports that can be active in the LAG simultaneously.
These ports can be moved into selected mode if one of the currently selected ports in the LAG
goes down.
● Mux State—Ability to transmit and collect data of the port
■ Waiting—Selected port that is waiting for LACP to determine if it can join the aggregator.
■ Attached—Ports ready to be added to the aggregator.
■ Collecting-Dist—Ports that are added to the aggregator and are transferring data.
■ Detached—Ports that cannot be added to the aggregator.
● Actor Flag—Mux state of the port
■ A—Activity
■ T—Timeout
■ G—Aggregation
■ S—Synchronization
■ C—Collecting
■ D—Distributing
■ F—Defaulted
■ E—Expired
● Partner Port
■ The operational value of the port number assigned to this link by partner.
● Up—Yes or no
● Enabled—Yes or no
● Unack count
● Wait-for-count
● Current timeout
● Activity mode
● Defaulted action
● Receive state
● Transmit state
● Selected count—Number of selected ports in the LAG
To Next Page
Loading...