Commands for Managing the Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
192
fdb 957 2 0 0 0 100% ON OK 1 (000008D3)
msgsrv 0 0 0 0 0 100% ON OK 1 (000008D3)
eaps 0 0 0 0 0 0% ON OK 1 (000008D3)
stp 1 0 0 0 0 0% ON OK 1 (000008D3)
esrp 1 0 0 0 0 100% ON OK 1 (000008D3)
polMgr 0 0 0 0 0 0% ON OK 1 (000008D3)
mcmgr 2 2 0 0 0 100% ON OK 1 (000008D3)
acl 0 0 0 0 0 100% ON OK 1 (000008D3)
netLogin 0 0 0 0 0 0% ON OK 1 (000008D3)
ospf 0 0 0 0 0 0% ON OK 1 (000008D3)
netTools 1 0 0 0 0 100% ON OK 1 (000008D3)
telnetd 0 0 0 0 0 0% ON OK 1 (000008D3)
rtmgr 4 4 0 0 0 100% ON OK 1 (000008D3)
vrrp 378 0 0 0 0 0% ON OK 1 (000008D3)
tftpd 0 0 0 0 0 0% ON OK 1 (000008D3)
thttpd 0 0 0 0 0 0% ON OK 1 (000008D3)
rip 0 0 0 0 0 0% ON OK 1 (000008D3)
dosprotect 0 0 0 0 0 0% ON OK 1 (000008D3)
epm 0 0 0 0 0 0% ON OK 1 (000008D3)
hal 0 0 0 0 0 0% ON OK 1 (000008D3)
bgp 0 0 0 0 0 0% ON OK 1 (000008D3)
pim 0 0 0 0 0 0% ON OK 1 (000008D3)
etmon 185 185 0 0 0 100% ON OK 1 (000008D3)
To view the output for a specific process, use the process option. The following command displays
detailed information for the STP process:
show checkpoint-data stp
The following is sample output from this command:
Process Tx Rx Errors Sent Total % Chkpt Debug-info
----------------------------------------------------------------------------
stp 1 0 0 0 0 0% ON OK 1 (000008D3)
History
This command was first available in ExtremeWare XOS 10.1.
An error count was added to the output in ExtremeWare XOS 11.1.
Platform Availability
This command is available only on modular switches.
To Next Page
Loading...