Extreme Networks ExtremeWare XOS - Page 1066

Network Login Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1066
● 10 Gigabit Ethernet ports such as those on the 10G4X I/O module and the uplink ports on the
Summit X450 family of switches do not support netlogin MAC-based VLANs.
If you attempt to configure netlogin MAC-based VLANs on 10 Gigabit Ethernet ports, the switch
displays an error message similar to the following:
ERROR: The following ports do not support the MAC-Based VLAN mode; 1, 2, 10
● You can have a maximum of 1,024 MAC addresses per I/O module or per Summit X450 family
switch.
Displaying FDB Information. To view netlogin-related FDB entries, use the following command:
show fdb netlogin [all | mac-based-vlans]
The following is sample output from the show fdb mac-based-vlans command:
Mac Vlan Age Use Flags Port List
------------------------------------------------------------------------
00:04:96:10:51:80 VLONE(0021) 0086 0000 n m v 1:11
00:04:96:10:51:81 VLTWO(0051) 0100 0000 n m v 1:11
00:04:96:10:51:91 VLTWO(0051) 0100 0000 n m v 1:11
00:04:96:10:51:11 VLTWO(0051) 0100 0000 n m 8:1
00:04:96:10:51:31 VLTEN(0051) 0100 0000 d m 8:10
Flags : d - Dynamic, s - Static, p - Permanent, n - NetLogin, m - MAC, i - IP,
x - IPX, l - lockdown MAC, M - Mirror, B - Egress Blackhole,
b - Ingress Blackhole, v - NetLogin MAC-Based VLAN.
The flags associated with netlogin include:
● v—Indicates the FDB entry was added because the port is part of a MAC-Based virtual port/VLAN
combination.
● n—Indicates the FDB entry was added by network login.
Displaying Port and VLAN Information. To view information about the VLANs that are temporarily added
in MAC-based mode for netlogin, use the following command
show ports <port_list> information detail
The following is sample output from this command:
Port: 1
Virtual-router: VR-Default
Type: UTP
Random Early drop: Disabled
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Active, 100Mbps, full-duplex
Link Counter: Up 1 time(s)
VLAN cfg:
Name: Default, Internal Tag = 1(MAC-Based), MAC-limit = No-limit
...<truncated output>
Egress 802.1p Replacement: Disabled
NetLogin: Enabled
NetLogin authentication mode: Mac based
NetLogin port mode: MAC based VLANs
Smart redundancy: Enabled