EAPS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1114
The VLAN must already exist before you can add it as a control VLAN. If you attempt to add a VLAN
that does not exist, the switch displays a message similar to the following:
* Switch.8 # configure eaps megtest add control foo
^
%% Invalid input detected at '^' marker.
To create the VLAN, use the create vlan command.
Example
The following command adds the control VLAN “keys” to the EAPS domain “eaps_1.”
configure eaps eaps_1 add control vlan keys
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...