IP Unicast Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1348
Usage Guidelines
Although these priorities can be changed, do not attempt any manipulation unless you are expertly
familiar with the possible consequences. If you change the route priority, you must save the
configuration and reboot the system.
NOTE
The priority for a blackhole route can not overlap with the priority of any other route origin.
Example
The following command sets IP route priority for static routing to 1200:
configure iproute priority static 1200
History
This command was first available in ExtremeWare XOS 10.1.
The route priority restrictions were added in ExtremeWare XOS 11.1.
The ipv4 keyword was added in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
BOOTP 5000
Table 26: Relative route priorities (Continued)
Route Origin Priority
To Next Page
Loading...