Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
334
If you attempt to enter a port number that is different that a LAG group ID, the system returns the
following error message:
ERROR: LAG group Id does not exist
NOTE
To force the LACP trunk to behave like a static sharing trunk, use this command to add ports to the aggregator.
Example
The following command deletes defaulted ports from the aggregator for the specified LAG group ID:
configure sharing 5:1 lacp defaulted-state-action delete
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...