Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
364
The following example defines a dynamic LAG on a stand-alone switch containing ports 10 through 15,
with port 10 being the logical port:
enable sharing 10 grouping 10-15 lacp
History
This command was first available in ExtremeWare XOS 10.1.
The address-based algorithm was added in ExtremeWare XOS 11.0.
The L2 and L3 optional parameters were added in ExtremeWare XOS 11.1.
IPv6-compatibility was added in ExtremeWare XOS 11.2.
Dynamic link aggregation, using LACP, was added in ExtremeWare XOS 11.3.
The L3_L4 optional parameter was added in ExtremeWare XOS 11.5.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...