Extreme Networks ExtremeWare XOS - Page 383

show lacp member-port
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
383
● Actor Flag
■ A—Activity
■ T—Timeout
■ G—Aggregation
■ S—Synchronization
■ C—Collecting
■ D—Distributing
■ F—Defaulted
■ E—Expired
● Partner Port
■ The operational value of the port number assigned to this link by partner.
● Up or Down—LACP protocol running or not on specified port
● Enabled or disabled (not configurable)
● Link State—Link state on this port up or down
● Actor Churn—True or false
● Partner Churn—True or false
● Ready_N—Ready to be added to aggregator.
● Wait pending
● Ack pending
● LAG Id
■ S—Displays information on controlling partner of LAG.
■ T—Displays information on controlled partner of LAG.
● Stats
■ Rx - Accepted
■ Rx - Dropped due to error in verifying PDU
■ Rx - Dropped due to LACP not being up on this port
■ Rx - Dropped due to matching own MAC
■ Tx - Sent Successfully
■ Tx - Transmit error
Example
The following command displays LACP information on the specified port:
show lacp member-port 4:9
The following is sample output from this command on a modular switch:
Member Port Rx Sel Mux Actor Partner
Port Priority State Logic State Flags Port
--------------------------------------------------------------------------------
4:9 300 Current Selected Collect-Dist A-GSCD-- 4009
================================================================================
Actor Flags: A-Activity, T-Timeout, G-Aggregation, S-Synchronization
C-Collecting, D-Distributing, F-Defaulted, E-Expired