Extreme Networks ExtremeWare XOS - Page 390

Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
390
Example
The following command displays the port configuration for all ports on a modular switch:
show ports configuration
Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
1:1 VR-Default E A ON AUTO 100 AUTO FULL SY/ASYM UTP
1:2 VR-Default E R ON AUTO AUTO UTP
2:1 VR-Default E R ON AUTO AUTO UTP
2:2 VR-Default E R ON AUTO AUTO UTP
3:1 VR-Default E R ON AUTO AUTO UTP
3:2 VR-Default E R ON AUTO AUTO UTP
4:1 VR-Default E R ON AUTO AUTO UTP
4:2 VR-Default E R ON AUTO AUTO UTP
5:1 VR-Default E R ON AUTO AUTO UTP
5:2 VR-Default E R ON AUTO AUTO UTP
5:3 VR-Default E R ON AUTO AUTO UTP
5:4 VR-Default E R ON AUTO AUTO UTP
5:5 VR-Default E R ON AUTO AUTO UTP
5:6 VR-Default E R ON AUTO AUTO UTP
5:7 VR-Default E R ON AUTO AUTO UTP
5:8 VR-Default E R ON AUTO AUTO UTP
5:9 VR-Default E R ON AUTO AUTO UTP
5:10 VR-Default E R ON AUTO AUTO UTP
.
.
.
.
5:106 VR-Default E R ON AUTO AUTO UTP
5:107 VR-Default E R ON AUTO AUTO UTP
5:108 VR-Default E R ON AUTO AUTO UTP
================================================================================
Link Status: A-Active, R-Ready, NP-Port not present
Port State: D-Disabled E-Enabled, Media: !-Unsupported XENPAK
0->Clear Counters U->page up D->page down ESC->exit
The following command displays the port configuration statistics for slot 2, port 2:
show ports 2:2 configuration
Following is sample output from this command:
Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
2:2 VR-Default E R ON AUTO AUTO UTP
================================================================================
Link Status: A-Active, R-Ready, NP-Port not present
Port State: D-Disabled E-Enabled, Media: !-Unsupported XENPAK
0->Clear Counters U->page up D->page down ESC->exit