Extreme Networks ExtremeWare XOS - Page 393

show ports information
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
393
If you do not specify a port number or range of ports, detailed system-related information is displayed
for all ports. The data is displayed in a table format.
This status information may be useful for your technical support representative if you have a network
problem.
The
detail parameter is used to provided more specific port information. The data is called out with
written explanations versus displayed in a table format.
NOTE
The keyword detail displays slightly different information depending on the platform and configuration you are
working with.
The link filter counter displayed with the detail keyword is calculated at the middle layer on receiving
an event. The link filter up indicates the number of link transitions from down to up at the middle layer
filter.
Example
The following command displays port system-related information on a BlackDiamond 8810 switch:
show port 3:1 information
Following is sample output from this command:
BD8810.4 > show port 3:1 info
Port Flags Link Link Num Num Num Jumbo QOS Load
State ELSM UPS STP VLAN Proto Size profile Master
=============================================================================
3:1 Em------e-- ready - 0 0 1 1 9216
==============================================================================
Flags : a - Load Sharing Algorithm address-based, D - Port Disabled,
e - Extreme Discovery Protocol Enabled, E - Port Enabled,
g - Egress TOS Enabled, j - Jumbo Frame Enabled,
l - Load Sharing Enabled, m - MACLearning Enabled,
n - Ingress TOS Enabled, o - Dot1p Replacement Enabled,
P - Software redundant port(Primary),
R - Software redundant (Redundant),
q - Background QOS Monitoring Enabled,
s - diffserv Replacement Enabled,
v - Vman Enabled, f - Unicast Flooding Enabled
M - Multicast Flooding Enabled, B - Broadcast Flooding Enabled
L - Extreme Link Status Monitoring Enabled
NOTE
The BlackDiamond 10808 series and 12804 switches have an additional flag: p - Load Sharing Algorithm
port-based.